![]() Slide the coupling to the joint of the shaft and motor shaft.You can adjust its tension by turning the screw. ![]() If you can't put the shaft through the timing belt, the possible cause is that the timing belt is set too tight. Put the shaft through the coupling, and then put it through the timing belt and insert it into the idler pulley.Otherwise, the timing belts may be damaged. The screws are used to set the tension of the timing belts. Use screws to hold the side plates together.Align the power switch, power port, and USB port with the openings on the right plate. Note that no scissors are included in the pack. Cut off the cable tie on the right plate.XTool D1 Pro Quick Start Guide-Part 3.pdf XTool D1 Pro Quick Start Guide-Part 2.pdf XTool D1 Pro Quick Start Guide-Part 1.pdf
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |